Rasmussen DFC7 Series Owner's Manual Page 1

1 THE GAS LOG COMPANY DOUBLE FACE CHILLBUSTER 7 Decorative Vented/Unvented Gas Log Set General Assembly, Installation, and Operation Instructions

10 View from behind burner 1. FRONT LOGS: Align the Front Log Guide Grooves (Figures 4 and 5) with right and left ends of the Front Burner (Figures

11 WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may

12 STEP THREE: VOLCANIC ASH PLACEMENT STEP FOUR: REMOTE RECEIVER PLACEMENT The Remote Receiver (-RE and -SE models) can be adversely affected by hea

13 Propane Thermocouple Air Intake Port B) Natural Gas Pilot Assembly (ODS-OP-N) Pilot Tube Piezo Sparker Air Intake Port Piezo Sparker Thermocouple

14 Wireless Wall Timer (30/60/120 Minutes)(WT-2R) VENTED MODELS IMPORTANT! CHIMNEY DAMPER MUST BE WIDE OPEN! THE

15 IMPORTANT ! THINGS TO REMEMBER; IMPORTANT! • Solid fuels shall NOT be b

16 Blue Blue and Yellow NORMAL OPERATING CHARACTERISTICS Each and every CHILLBUSTER™ that leaves the factory is quality checked to ensure compliance

17 ® NOTE—The installation of appliances in a manufactured home (U.S. only) or mobile home installation must conform with the Standard CAN/CSA Z240

18 ® LIMITED WARRANTY: RASMUSSEN IRON WORKS INC, 12028 E. Philadelphia Street, Whittier California, U.S.A., warrants this Gas Fire Set and accessor

2 CARBON MONOXIDE POISONING MAY LEAD TO DEATH When used without fresh air, decorative gas appliances may give off carbon monoxide, an odorless, col

3 Table of Contents Pages 1-2………….Warnings and Standards Pages 3-4………...….Parts and Accessories Page 5………………...Spacing Calculations Page 6………...Com

4 8. V1 Valve Assembly 9. V2 Valve Assembly 10 Short Valve Key (K1) 11 Long Valve Key (K2) (V1/V2 Valve Assembly) 12. Stand Alon

5 This heater shall not be installed in a “confined” space or unusually tight construction unless provisions are provided for adequate combustion an

6 For our example, we have chosen to add to our Total Volume of the Space by removing the door to an adjoining study and increasing our Maximum Suppo

7 *Standard Fireplace Hood with a minimum 4 inch horizontal projection. Horizontal projection from face of fireplace 10” 8” 6” 2.5” .75” 10” 8” 6”

8 FIGURE 2 A) Damper Clamp B) Damper Blade Flue Opening Height (17” Minimum) Side View of Two sided Firebox Gas Supply Pipe FIGURE 1 Log Lighter

9 STEP TWO: BURNER INSTALLATION AND GAS SUPPLY CONNECTION 1. Insure that the Gas Supply to the Fireplace is turned off and verify correct gas type